Installing the new rear Bumper
The installation of the rear bumper was fun. I had never seen this view of my car before.
Removing the rear bumper was no difficult task and again I was suprised how light the bumper and how heavy the trim are.
The pictures here really show off how purposeful my exhaust is. It is in fact so puposeful that it took me a couple of hours of cut and fit to get the bumper to clear the 3.5 inch exhaust tip! Honduhs run in fear! My car really needs that much exhaust!
The rain couldn't hold me back. But I ran out of steam and had to pick up the next day after work.
I had to remove the muffler to do a test fit of the bumper, then I could reinstall the muffler, check the fit, grind and check again.
These shots show off my high power beer-cans I will get the heater fixed soon and then I will no longer have domestic beers on my car!
I went ahead and used stock license plate lights. I also mounted the license plate on spacers.
I used a hole cut saw to cut a couple of vents under the plate to assist in getting the heat off of the muffler.
